The truck bed cover especially bakflip MX4 installation also known as tonneau cover process. This is a straightforward process and not as difficult as we think. This can be accomplished at home with some basic tools and a little time.
Admiring, you will be capable of installing the tonneau cover for truck bed By the end of this blog post.
This guide will walk you through the installation steps. This ensures that you can enjoy the benefits of added security and protection for your truck bed.
Bakflip MX4 Installation Details:
The BakFlip MX4 is a hard folding tonneau cover designed for durability and ease of use. It features heavy-duty aluminum panels that can support over 400 lbs. This provides excellent protection against the elements while allowing full access to your truck bed.
The MX4 also includes weather-resistant features and an automatic latching system. These features improve security.
Now, here are some important questions to ask yourself before moving to the next step in bakflip installation process.
- Is my truck compatible with the BakFlip MX4?
- What tools do I need for installations?
- Have I read the installation instructions?
- Do I need additional weather stripping or seals?
- Am I comfortable with DIY installations?
Bakflip Bed Cover Install Required Tools:
Before you begin the installation, gather the following tools which has been listed below:
- Phillips head screwdriver
- Measuring tape
- Utility knife (if needed)
- Safety glasses and gloves for protection
Bakflip Installation Process Step-By-Step Guide:
By the end of these steps, you will be capable in installing bakflip MX4 cover for your turck.
- Prepare Your Truck Bed:
Make sure your turck bed is clean and free of debris. This will help create a proper seal and prevent scratches during installation.
- Checking Compatiablity:
Verify that the Bakflip MX4 is compatible with your truck model. This cover is designed to fit specific truck beds. This is the reason for double check the dimensions before proceeding.
- Lay Out the Parts:
Now, in the case of open the packaging and laying out all components, including the side rails, clamps, and the cover itself.
- Install Side Rails:
Start by placing the side rails on each side of your truck bed. The silver brackets should align with the bed rail.
- Attach Clamps:
Secure each side rail using the provided clamps from these positions:
- Position the first clamp approximately 6 to 9 inches from the front of the truck bed.
- Place another clamp about 6 inches from the tailgate
- Tighten each clamp hand tight initially to allow for adjustments later
- Secure Side Rails:
After that, use flat bolts and hardware to secure the cover, by the insert flat bolts through pre-drilled holes in the front panel into silver brackets attached to side rails.
Moreover, you can use rubber washers followed by flat washers and lock washers before securing with finger knobs underneath
- Install Cab Bumpers:
Install three cab bumpers along the top edges of the cover where it meets your truck cab. These bumpers help cushion and protect against vibrations while driving.
- Final Adjustments:
Now at the end, you need to unfold the cover towards the rear of your truck. This ensures it fits squarely between both rails. The aluminum frame should sit just inside the tailgate.
- Test Functionality:
Test opening and closing mechanisms to ensure they operate smoothly without binding or obstruction. Moreover, inspect all seals to confirm they are tight and provide adequate protection against water intrusion.
Final Thoughts:
Bakflip Mx4 Installation improves both security and functionality for your truck bed. I hope the following questions and steps helped your understand. However, knowing the maintenance of bakflip bed cover install is also important.
That’s it as of now for today, do follow us and share your thoughts in the comments and follow us to get such informative blogs daily. Thank you, everyone, George Jordan this side from Toolbox Bazar.
